TS2100 C-Band Multimode Transmitter

The C-Band Multimode Transmitters Series TS2100 are designed for Bandwidth efficient transmission Of digital data. Operational parameters like carrier frequency, output power, etc. are programmable via serial interface (V24 on RS-232/RS-485). The TS2100 transmitters are of very small size, low mass and high efficiency and are designed to meet IRIG 106-15 standards.

RF Output

Frequency Range 5091 to 5250 MHz
Frequency Selection within 100MHz band programmable in 100kHz steps
Frequency Stability ≤ ± 0,002%
Output Power 1 to 10 Watts, min.
Output Impedance 50 Ohm
Harmonics, Spuria ≤ -60 dBc
Open/Short Protection yes
Turn-on start-up time 1 sec. max.

Modulation

Type PCM/FM, SOQPSK, multi-h
Input Data + Clock
  TTL or RS-422
Signal Range 1 to 40 Mbps (NRZ)

DC Power

Power Supply 24 … 32 VDC
Rev. Voltage Protection yes
Overvoltage Protection for spikes up to 50 V/10 ms
Power Consumption 1.4A , typ. @ 28VDC (5 Watts)

Connectors

RF Connector SMA -f
Mod./Power Connector HD-SUB 15 male

Physical Data

Dimensions 90 x 70 x 27 mm (L x W x H)
Weight approx. 400 grams

Environmental

Temperature Range at base plate
operational: -40C to +85C
storage: -55C to +100C
Relative Humidity 10% … 90% r.H., non-condensing
Shock 100 g, 11 ms, half sine, 3 axis
Vibration 20 grms, 10 Hz to 2000 Hz
Acceleration 100g
Altitude unlimited

Aktuell

Spende 2020

STT spendet an die "Tabaluga Kinderstiftung"

[mehr]

ROKVISS/KONTUR beendet

ROKVISS/KONTUR nach 16 Jahren Betrieb beendet.

[mehr]

ESAIL launched

ESAIL successfully launched onboard VEGA VV16

[mehr]

Veranstaltungen

Kontakt

STT-SystemTechnik GmbH

Gneisenaustraße 15
D-80992 München

Tel.:+49 (0)89 500 590-0Fax.:+49 (0)89 500 590-299Email:mail(at)stt-systemtechnik.de
TÜV ISO 9001
Innovativ durch Forschung 2014/2015